![]() Lay out the PVC pipes for the supply lines and run them to their respective water jets. Use a hacksaw to make any cuts in the length of pipe and elbows to curve the pipe around any obstructions or angling the pipe in the right direction. Step 4: Connect Skimmer PipesĪgain, using the same technique of cleaning and gluing the 1 1/2 inch PVC pipes, start to lay out the pipes from the skimmer to where the pump will be. ![]() This pipe should run towards an area of your landscape where the water can drain. On the end of the elbow place a section of straight pipe. Use the same technique of applying PVC cleaner and then the glue. ![]() Start with the drain of your pool and place a 90-degree elbow onto the end of the coupling. It must be laid out in a certain way so that you do not have to continually dig up the ground to fix any problems. Inground pool plumbing is going to be hidden under the ground and patio. These couplings are needed for connecting the different pipes to each section. You should do this for each of the different items mentioned. Then apply some glue to each of the components and slide the two pieces together. Use some PVC cleaner on each of the ends of the couplings and housing for the skimmer, drain, and water inlets. They will be connected to the piping behind them and will be held in place by the concrete liner of the pool. Each of these components basically slides into the openings. Most kits come with everything you need for a successful installation. Before any of the finish steps are taken with your inground pool you can use a basic tool kit for the items like a skimmer, drain, and water inlets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |